- Wooveconnect 2
- Stability vs speed
Stability vs speed
If you find bi-directional connections unstable when uploading data to your Woovebox, you can use the stability vs speed control to tradeoff throughput for stability.
And vice versa, if you have a very stable connection and wish to increase throughput, you may trade stability for increased speed.
If packet loss is detected on a bi-directional connection on firmware 3157+, this setting is automatically adjusted down in an attempt to enhance connection stability.
You may also be interested in...
- Elektronauts Woovebox Thread (under Socials, Discord, and forums)
An active thread on the Elektronauts forums with support, tips, tricks and updates.
- 10/A2 Enable remote control expander mode (under Boot modes)
To start your Woovebox with remote control expander mode enabled, hold 10/A2.
- 4. S.Lvl Send Level (under Dynamics)
The volume/strength (0-127) of the signal generated from this track that should be sent to the send bus ('S.buS').
- Line input (under MIDI, Sync and connecting other gear)
'In 2' uses audio from the incoming audio's right channel as if it were an oscillator source.
- MIDI out (under MIDI, Sync and connecting other gear)
MIDI CC 71, Filter resonance, sends a track's filter resonance (not sent if using XG/GS NRPN mode instead).