- Guides, tutorials and docs
- Learning the Woovebox
- The very basics
- Quick start guide and video
- Tempo and BPM
- Tracks
- Patterns
- Live pattern recording
- Conditional triggering and modification
- Chords
- Arpeggios
- Scales and modes
- Full song writing
- Genres
- Presets
- Sound design
- Paraphonic parts
- Multi-instrument mode
- Risers, fallers, sweeps & ear candy
- Live mode
- Song mode
- Sampler
- Sidechaining, gating, ducking and compression
- Mastering
- Lo-fi & vintage analog and digital emulation
- Randomization
- Hall effect sensor playing
- Advanced techniques
- Undo
- Boot modes
- MIDI, Sync and connecting other gear
- Wireless MIDI over BLE
- Battery and charging
- Hardware quirks and limitations
- Understanding DSP load
- Looking after your Woovebox
- Firmware updates
- Boot modes
- Boosted screen brightness / version
Boosted screen brightness / version
By keeping 5/ki pressed while turning the device on, screen and LED brightness can be temporarily increased from its default brightness. This may be useful if the default brightness is insufficient (for example in sunny outdoor scenarios). Turn the value knob to change the brightness. Press the value knob to continue the boot sequence (which should normally amount to a 1-2 second delay before dropping into Song mode). The device will display the firmware version it is running, until the boot sequence is complete.
You may also be interested in...
- Offers
- Turning off Wooveconnect CC messages (under MIDI, Sync and connecting other gear)
As of firmware 2817, device mirroring is off by default, if the device was not booted up with BLE enabled.
- 5. noi.F Noise Floor (under Glob (song globals) page)
Sets a base noise floor (0-127) below which artificially introduced noise is always audible.
- 9. MC.th Master Compressor threshold (under Glob (song globals) page)
Sets the threshold (0-100) above which the master compressor/limiter should kick in.
- Emulating vinyl (under Lo-fi & vintage analog and digital emulation)
A positive value will play the vinyl crackle even when no pattern or song is playing.
- Guides, tutorials and docs
- Learning the Woovebox
- The very basics
- Quick start guide and video
- Tempo and BPM
- Tracks
- Patterns
- Live pattern recording
- Conditional triggering and modification
- Chords
- Arpeggios
- Scales and modes
- Full song writing
- Genres
- Presets
- Sound design
- Paraphonic parts
- Multi-instrument mode
- Risers, fallers, sweeps & ear candy
- Live mode
- Song mode
- Sampler
- Sidechaining, gating, ducking and compression
- Mastering
- Lo-fi & vintage analog and digital emulation
- Randomization
- Hall effect sensor playing
- Advanced techniques
- Undo
- Boot modes
- MIDI, Sync and connecting other gear
- Wireless MIDI over BLE
- Battery and charging
- Hardware quirks and limitations
- Understanding DSP load
- Looking after your Woovebox
- Firmware updates