- Dynamics
- r.buS
1. r.buS Receive Bus
Specifies which bus should be used for the signal that will control the volume attenuation for this track. Four busses are available, as well as a 'faKE' setting that fakes a pulse on every first quarter note without any input signal. The latter is quick way to mimic the "pumping" effect found in many dance tracks.
You may also be interested in...
- 16. L.C.ho hold duration for cutoff frequency LFO (under Filter page)
Specifies the hold duration in milliseconds for which the LFO should hold the LFO's sampled value.
- How to approach (under Learning the Woovebox)
- 4/Ar + value Factory reset (under Boot modes)
Please note that the following procedure will cause all data (songs, samples, patches) on the device to be lost!
- 6/Sn Increase capacitive button sensitivity (under Boot modes)
By keeping 6/Sn pressed while turning the device on, sensitivity of the capacitive buttons can be temporarily increased.
- 4. n.V.En Noise Volume End (under DJ page)