16. Hal.S South pole Hall sensor mapping
Specifies which parameter the detected south pole magnetic field strength should map to;
- 'Off'; the sensor will not respond to a magnet for this polarity
- 'Fltr'; magnet proximity will cause filter to close for this polarity
- 'FLFO'; magnet proximity will cause filter LFO to modulate filter cut-off frequency for this polarity
- 'PLF.1'; magnet proximity will allow pitch LFO 1 to modulate for this polarity
- 'PLF.2'; magnet proximity will allow pitch LFO 2 to modulate for this polarity
- 'PL.1.2'; magnet proximity will allow pitch LFO 1 and 2 to modulate for this polarity
- 'Vol'; magnet proximity will cause volume to decrease
- 'ALF.1'; magnet proximity will allow amplitude LFO 1 to modulate for this polarity
- 'ALF.2'; magnet proximity will allow amplitude LFO 2 to modulate for this polarity
- 'AL.1.2'; magnet proximity will allow amplitude LFO 1 and 2 to modulate for this polarity
You may also be interested in...
- Method 2 (under Arpeggios)
This technique is much more in line with the old school way of creating arpeggios.
- 16. St.Ho Start Position LFO Hold (under Panning page)
Specifies the hold time for the start position LFO in milliseconds.
- 6. A.L.tr Amplitude LFO trigger (under Osc1 and Osc2 oscillator page)
'rand' will start the LFO at a random phase (location in the chosen waveform).
- 10. L1.dp LFO 1 Depth (under Pitch page)
Negative values change the waveform phase 180 degrees (e.g. waveform changes polarity).
- 14. L2.dp LFO 2 Depth (under Pitch page)
Negative values change the waveform phase 180 degrees (e.g. waveform changes polarity).