- Sound design
- Architecture
- Oscillators
- Algorithms
- Low Frequency Oscillators (LFOs)
- Envelope generators
- Filters
- Amplitude modulation
- Pitch modulation
- Panning & EQ
- Dynamics, Sidechaining, Gating, Ducking, Compression and Transient Shaping
- Distortion, Saturation, Bit-crushing
- Global Send Multi-effects
- DJ FX
- Wavetable Synthesis
- A word about authenticity
7. P.L.tr Pitch LFO retrigger
Defines what should happen to the oscillator's pitch LFO ("Low Frequency Oscillator") when a new note is triggered;
- 'FrEE' will not cause the LFO to restart
- 'Retr' will cause the LFO to restart
- 'Cond' will only cause the LFO to engage if the step that triggered the note has a valid ('when') 'PLFO' condition ('do') set.
- 'rand' will start the LFO at a random phase (location in the chosen waveform)
You may also be interested in...
- Reviews, videos, tutorials (under Downloads & Community)
- 13. L.C.Wv Waveform for cutoff frequency LFO (under Filter page)
'Sqr'; square wave (starts at 1 for a half a cycle, then switches off for half a cycle).
- 4. S.Lvl Send Level (under Dynamics Page)
The volume/strength (0-127) of the signal generated from this track that should be sent to the send bus ('S.buS').
- Dynamics, Sidechaining, Gating, Ducking, Compression and Transient Shaping (under Sound design)
- 1. r.buS Receive Bus (under Dynamics Page)
Specifies which bus should be used for the signal that will control the volume attenuation for this track.
- Sound design
- Architecture
- Oscillators
- Algorithms
- Low Frequency Oscillators (LFOs)
- Envelope generators
- Filters
- Amplitude modulation
- Pitch modulation
- Panning & EQ
- Dynamics, Sidechaining, Gating, Ducking, Compression and Transient Shaping
- Distortion, Saturation, Bit-crushing
- Global Send Multi-effects
- DJ FX
- Wavetable Synthesis
- A word about authenticity