Analog sync

Even today, analog sync pulses are a popular way to start, stop and synchronize playback of other gear. Your Woovebox can output an analog sync pulse via a breakout cable (a fairly standard cable that is normally used to split mic and stereo headphones) that connects to the headphone output jack.

To enable the sync pulse, switch to Song mode. scroll to the 'GLob' page, and change the 'Sync' parameter under the 13/A5 key to 'on'.

Note that enabling 'Sync' without using the breakout cable, may cause a faint clicking noise. Therefore, keep this setting at 'off' if the breakout cable is not in use.

Please do not attempt to listen to the sync pulse with headphones without attenuating the signal externally first. While low and electrically safe, the ~2.7V signal is very loud and may damage your headphones or hearing. Please also note that the ~2.7V voltage may not be sufficient to drive some older analog gear that expects higher voltages.

Analog sync has been successfully tested with the Teenage Engineering Pocket Operator series, as well as the KORG Volca series.